Extron Electronics MGP Pro Series User Guide - Manual (Page 18)

MGP Pro Series • Operation 12
Operation
This section describes the setup and operating procedures for the MGP Pro and includes
the following sections:
• Front Panel Features
• Power-up and Default Cycle
• Window Select Buttons
• Input Selection
• Menus, Configuration, and Adjustments
• Picture Controls
• Auto Memories
• Memory Presets
• Additional Functions
You can set up and operate the MGP Pro using:
• The front panel controls
• A computer, a touch screen panel, or any other device that can send and receive serial
communications through either serial port or the LAN port. Settings can be adjusted
through the host computer using SIS commands or the Windows-based control
software.
• A computer or other device using an Ethernet connection and IP protocol (Telnet or a
web browser).
This section discusses the functions available through the front panel. For details on setup
and control via RS-232 or RS-422, see the
Remote Configuration and Control section
beginning on page 42. For web page control, see the HTML Configuration and Control
section beginning on page 84.
Front Panel Features
Figure 10. MGP 464 Pro Front Panel