Extron Electronics MGP Pro Series User Guide - Manual (Page 86)

MGP Pro Series • Remote Configuration and Control 80
Command
ASCII (Telnet)
(Host to Processor)
URL Encoded (Web)
(Host to Processor)
Response
(Processor to Host)
Additional Description
Reset (Zap) / Erase Commands (continued)
Reset all device
settings to factory
default
24
E ZXXX } W ZXXX | Zpx ] IP-related settings and flash
memory are
not reset.
Absolute system
reset
24
E ZQQQ } W ZQQQ | Zpq ] Reset all settings and
memories, including all
adjustments, the IP address,
and the subnet mask, to
the factory default values.
The IP address is reset
to 192.168.254.254, and
the subnet mask is set to
255.255.0.0 (identical to
reset mode 5).
Absolute reset
retaining IP
24
E ZY } W ZY | Zpy ] Same as Absolute system
reset (
E ZQQQ) except
that IP settings, including
IP address, subnet mask,
gateway address, unit
name, DHCP setting, and
port mapping (Telnet/
web/Direct Access) are
excluded in order to preserve
communication with the
device (recommended after a
firmware update).