Extron Electronics MGP Pro Series User Guide - Manual (Page 26)

MGP Pro Series • Operation 20
Input Configuration Menu
The Input Configuration menu allows you to select a video signal type for each of the four
fully configurable inputs. All of these inputs can accept the following video signals: RGB,
YUV-HD, YUVi, RGBcvS, S-video, composite video, HDMI (MGP Pro DI and 3G-SDI models
only), and 3G/HD-SDI (MGP Pro 3G-SDI models only). RGB is the default. You can also
select the horizontal and vertical start positions, pixel sampling phase for each window
(except for YUVi, S-video, and composite video inputs), film mode, total pixels, active pixels,
and active lines for each input. Rotate the horizontal Adjust ([) knob to cycle through and
select one of the four inputs, and the vertical Adjust knob ({) to adjust the setting.
NOTE: From any menu or submenu, the MGP Pro saves all adjustment settings and
times out to the default screens after 20 seconds of inactivity.
Figure 16. Input Configuration Menu Flow
NOTE: The 15 virtual inputs (numbered 5 through 19) cannot be configured from the
front panel. You must use SIS commands or the Windows-based control software to
configure them.