Extron Electronics IN1608 MA User Guide - Manual (Page 85)

IN1606 and IN1608 Series Scaling Presentation Switcher • Internal Web Pages 79
Ducking parameters
Ducking lowers the level of microphone or program material (based on a source signal from
another microphone) for the duration of the signal that is present at the source microphone.
It restores the original level after the source signal ceases and after the hold and release
times are met. This is useful when:
• Program material must be attenuated in order to accentuate the voice of a narrator.
• One microphone is used by a chairman or master of ceremonies and must have priority
over other microphones and program material.
• A paging microphone must attenuate all other signals.
To apply ducking for microphone inputs:
1. Click the Mic/Line Input tab.
2. From the desired Mic/Line input panel, select the Enable Ducking check box. The
following ducking options become available:
• Threshold — Sets the input signal level in dB that the ducking source must exceed
before ducking begins. The default is -30 dBFS.
• Hold time — Determines the time in ms after a ducking source signal drops below
the threshold before ducking ceases. The default value is 1000 ms.
• Release time — Determines how long in ms the ducking targets take to restore
signal levels after the ducking source level is below the threshold and the hold time
is met.
• Duck (targets) — Shows all potential targets to be attenuated when ducking is
enabled.
• Duck by (attenuation) — Attenuates the corresponding duck target in dB.
3. In the Threshold field, adjust the value by one of the following methods:
• Enter a value in the Threshold field and press the or key.
• Click the Up or Down arrow buttons.
If ducking does not occur quickly enough to avoid loss of speech or program
material from the ducking source, decrease this setting. If ducking occurs too soon,
allowing background noise to trigger ducking, increase the setting.
4. In the Hold Time field, adjust the value by one of the following methods:
• Enter a value in the Hold Time field and press the or key.
• Click the Up or Down arrow buttons. The default value is 1000 ms.
5. In the Release Time field, adjust the value by one of the following methods:
• Enter a value in the Release Time field and press the or key.
• Click the Up or Down arrow buttons.
6. In the list of Duck (target) check boxes, select the targets to attenuate when the
threshold is met. Only selected inputs are ducked.
NOTE: Only one mic input can be selected as a duck target at a time.
7. For those targets checked in step 6, adjust the adjacent Duck By field in one of the
following methods:
• Enter a value in the Duck By field and press the or key.
• Click the Up or Down arrow buttons. The default is 20 dB. If additional attenuation of
a target is required, increase this value.