Extron Electronics IN1608 MA User Guide - Manual (Page 50)

IN1606 and IN1608 Series Scaling Presentation Switcher • SIS Configuration and Control 44
Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Output Configuration Commands
Output scaler rate
Set output rate EX5( RATE } Rate X5(] Set the output resolution and rate to
X5( .
View output rate E
RATE
} X5(] View the selected output rate.
HDMI output format
Set format EX@ * X3@ VTPO } Vtpo X@ * X3@] Set the color space and format of
output
X@ to X3@ .
View setting EX@
VTPO
} X3@] View the color space and format setting.
Power save mode
Power save off E 0PSAV } Psav0 ] Operate at full power.
Power save on E 1PSAV } Psav1 ] Operate in a low power state. No video
output.
View setting E
PSAV
} X3&] View the power mode.
Screen saver
Set mode E M X2& SSAV } SsavM X2&] Set the color of the screen saver to X2& .
View mode E MSSAV } X2&] View the color of the screen saver.
Set time-out duration E T X2# SSAV } SsavT X2#] Set the time-out duration to X2# .
View time-out duration E
TSSAV
} X2#] View the time-out duration.
View screen saver status E
SSSAV
} X3*] View the screen saver status.
NOTES:
X@ = Output selection 1 = HDMI A (top)
2 = HDMI B (bottom)
3 = DTP C (IN1608 models)
X2# = Output sync timeout 0 = output sync is instantly disabled with no active input
1-500 (in 1 second increments)
501 = output sync never times out
X2& = Screen saver mode 1 = black output (default)
2 = blue output
X3@ = HDMI output format 0 = auto (default)
1 = DVI RGB 444
2 = HDMI RGB “Full”
3 = HDMI RGB “Limited”
4 = HDMI YUV 444 “Full”
5 = HDMI YUV 444 “Limited”
6 = HDMI YUV 422 “Full”
7 = HDMI YUV 422 “Limited”
X3& = Power save mode 0 = full power mode (default)
1 = low power state
X3* = Screen saver status 0 = active input detected, timer not running
1 = no active input, timer running, output sync enabled
2 = no active input, timer expired, output sync disabled
X5( = Output rate 3-8,10-92,201,202 ( see the X5( definition on page 37).