Extron Electronics IN1608 MA User Guide User Manual
Page 63
IN1606 and IN1608 Series Scaling Presentation Switcher • Configuration Software
57
Connect
This option connects a device tab in emulation mode to
a device. The page goes from emulation mode to live
mode and current device settings are displayed. The tab
indicator changes from gray (not connected) to green
(connected).
NOTE: If a device is already connected, the
Connect
option is disabled until the device is disconnected or
the connection times out.
1.
From the
Connections
menu, select
Connect
. The
Connection Settings window opens (shown at right).
2.
Select the connection method from the list of radio
buttons.
•
Select the
TCP/IP
radio button if the device is connected to the host device
through a LAN or WAN.
Enter the device IP address or hostname in the
IP Address
field. If the device is
password-protected, enter the password in the
Password
field.
•
Select the
RS-232
radio button if the device is connected to the host device
through an RS-232 connection.
Select the desired values from the
COM Port
and
Baud Rate
drop-down menus.
NOTE: The default baud rate is 9600.
•
Select the
USB
radio button if the device is connected to the host device through
the front panel mini-USB connector. Select the device from the list of devices.
3.
Click the
OK
button to connect to the device.
Disconnect
This option disconnects the PCS program from the connected device and returns it to
emulation mode.
From the
Connections
menu, select
Disconnect
. The scaler tab enters emulation mode.
NOTE: If a device is already disconnected, the
Disconnect
option is disabled until the
device is connected.
Exit
This option disconnects the scaler from the software and closes the application.
From the
Connections
menu, select
Exit
. The application closes.