Extron Electronics IN1608 MA User Guide - Manual (Page 58)

IN1606 and IN1608 Series Scaling Presentation Switcher • SIS Configuration and Control 52
Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
IP Control Port Commands
IP setup
NOTE: Changes made to any TCP/IP settings do not take effect until the reboot networking command
( E 2BOOT } ) is issued.
Set IP address 24 EX4)
CI
}
Ipi •X4)] Set the IP address to X4) .
Read IP address 24 E
CI
} X4)] View the current IP address.
Set DHCP mode EX(
DH
}
Idh
X(] Enable or disable DHCP.
View DHCP mode E DH } X(] View the DHCP mode setting.
Set subnet mask 24 EX4! CS } Ips •X4!] Set the subnet mask to X4! .
View subnet mask E CS } X4!] View the subnet mask setting.
Set gateway IP address 24 EX4@ CG } Ipg •X4@] Set the gateway IP address to X4@ .
View gateway IP address E CG } X4@] View the gateway IP address setting.
Read MAC address E
CH
} X4#]
Iph •X4#]
00-05-A6-xx-xx-xx
Verbose mode 2 and 3.
Query the number of open
connections E
CC
} X4$]
Icc
X4$]
View the number of open
connections.
Verbose mode 2 and 3.
Reboot networking E
2BOOT
}
Boot2
] Restart the network after IP setting or
DHCP changes.
NOTE: Changes to IP or DHCP settings will not take effect until the E
2BOOT
} command is executed.
NOTES:
X( = Enable or disable 0 = off or disabled
1 = on or enabled
X4) = IP address xxx.xxx.xxx.xxx ( 192.168.254.254 = default)
X4! = Subnet mask xxx.xxx.xxx.xxx ( 255.255.0.0 = default)
X4@ = Gateway address xxx.xxx.xxx.xxx ( 0.0.0.0 = default)
X4# = MAC address 00-05-A6-xx-xx-xx
X4$ = Number of open connections 0-<maximum number of open connections>