Xylem H-5223 - Manual (Page 88)

x.xxx: channel A voltage
y.yyy: channel B voltage
Example: -> SDIDATA0 5 Command sent to the XL™.
+1.234+9.876 rs Response from the XL™.
Command: SDIEXTENDED=<command>
Description: Issue an extended command on the SDI-12 bus using the address specified by
SDITESTADDRESS.
Parameters: “command” is the command that is to be issued on the SDI-12 bus. It needs to be a
valid SDI-12 command.
Response: The XL™ takes the response it receives on the SDI-12 bus and returns it. If no
response is received, the XL™ responds with “Communication Timed Out”. The
response to the extended command depends entirely on the command.
Example: -> SDIEXTENDED=*A
5 Command sent to the XL™.
1
rs Response from the XL™.
C.9 Output Commands
Command: AUTOPRINT?
Description: Read the auto print flag. If this flag is set, all data being logged also gets sent out
the serial port.
Parameters: None.
Response: An ASCII text string is returned with either “On ” or “Off“.
Example: -> AUTOPRINT? 5 Command sent to the XL™.
Auto Print = Off rs Response from the XL™.
Command: AUTOPRINT=XXX
H-5223
Remote Operation (Command Mode) C-29