Xylem H-5223 - Manual (Page 70)

Parameters: None.
Response: An ASCII text string is returned with the line feed delay. The line feed delay is an
integer value. The response is terminated using a carriage return, line feed.
Example: -> LINEFEEDDELAY? 5 Command sent to the XL™.
Line Feed Delay = 0 rs Response sent to the host system.
Command: LINEFEEDDELAY=XXX
Description: Set the character delay. The character delay is how long the XL™ delays in
milliseconds between sending characters out the serial communications port.
Parameters: There are 4 valid flow control settings, “None”, “HW”, “SW”, and “Both”.
Response: None, use the LINEFEEDDELAY? command to see the new value.
Example: -> LINEFEEDDELAY=50
5 Command sent to the XL™.
rs Response from the XL™.
Command: RESETDEFAULTS
Description: This command is used to force the unit to run through the power up sequence.
This will cause the unit to reinitialize some of the system variables, initialize the
real time clock and then turn off. The ENTER key must be pressed a few times
again to wake up the unit. This has the same effect as if the power is removed and
then restored.
Parameters: None.
Response: None.
Example: -> RESETDEFAULTS 5 Command sent to the XL™
C.3 Status Commands
Command: FIRMWAREVERSION?
Description: Read the XL™’s firmware version number.
H-5223
Remote Operation (Command Mode) C-11