Xylem H-5223 - Manual (Page 83)

by the trigger type, the channel is activated.
Parameters: There are two digital channels, so n can be either 1 or 2.
Response: An ASCII string containing a real number is returned for the trigger point.
Example: -> DIGITAL1TRIGGERPOINT? 5 Command sent to the XL™.
Digital 1 Trigger Point = 5.75 rs Response from the XL™.
Command DIGITALnTRIGGERPOINT=
Description: Write the trigger point of the n th digital channel. The trigger point is compared to
the value of the trigger source, and if the comparison meets the condition specified
by the trigger type, the channel is activated.
Parameters: There are two digital channels, so n can be either 1 or 2. The command accepts a
real number for the trigger point.
Response: None.
Example: -> DIGITAL1TRIGGERPOINT=4.25 5 Command sent to the XL™.
rs Response from the XL™.
Command DIGITALnPULSELENGTH?
Description: Read the pulse length of the n th digital channel. The pulse length is the amount of
time in milliseconds that the digital channel outputs a signal. This is also used for
the warmup delay when the digital I/O pin mode is set to “On For Scan”.
Parameters: There are two digital channels, so n can be either 1 or 2.
Response: An ASCII string containing an integer number is returned for the pulse length.
Example: -> DIGITAL1PULSELENGTH? 5 Command sent to the XL™.
Digital 1 Pulse Length = 200
rs Response from the XL™.
Command DIGITALnPULSELENGTH=
Description: Write the pulse length of the n th digital channel. The pulse length is the amount of
time in milliseconds that the digital channel outputs a signal. This is also used for
the warmup delay when the digital I/O pin mode is set to “On For Scan”.
C-24 Remote Operation (Command Mode)
H-5223