Xylem H-5223 - Manual (Page 106)

Analog Input Setup 2 to 4
Digital I/O 2 Setup (B - Back)
H-5223 Main Menu
V - View Status
I - Sensor Input Options
D - Data Options
O - Output Options
S - Scan Options
C - Configure System
X - Exit
Enter Option >
H-5223 Menu Tree
Version 1.0
View Status (B - Back)
Site ID: Site_ID
Time: 01:02:03
Date: 08/27/04
Scanning: Off
Next Scan:XX:XX:XX
GOES Mode:Off
M - More
Enter Option >
View Status (B - Back)
Battery: 12.4
Batt Max: 13.6
Batt Min: 11.2
System Resets: 1
Version: 1.00
Checksum: Pass
R - Reset Batt & Resets
Enter Option >
Data Options (B - Back)
Data Status: Ok
Bytes Free: xxxxxx (0% Full)
File Count: 1 of 8
T - Transmit Data
N - Transmit New Data
R - Reset New Data Pointer
L - Erase Last File
E - Erase All Data
Enter Option >
Scan Options (B - Back)
Current Time: 05:12:13
Next Scan: XX:XX:XX
S - Scanning: Off
R - Scan Rate: 00:15:00
N - Next Scan At:XX:XX:XX
Enter Option >
Sensor Input Menu (B - Back)
Dig I/O #1: 0 (DIG IN)
Dig I/O #2: 0 (DIG IN)
Ana 1: 0.002 Ana 3: 0.134
Ana 2: 1.234 Ana 4: 2.750
D - Digital I/O Setup
A - Analog Input Setup
G - Generic SDI_12 Options
Enter Option >
Digital I/O 1 Setup (B - Back)
V - Digital I/O 1 Valu: 0
I - I/O 1 Mode: DIG IN
L - Pulse/Delay: 0000 mS
C - Ctr/Encdr Inc: 0.01
S - Trig Source: None
T - Trig Type: > Set Pt
P - Trig Set Point: 1.000
1 - Test Output
Enter Option >
Analog Input Setup (B - Back)
Analog 1: 0.012
S - Slope: 1.000
O - Offset: 0.000
D - Differential Mode: Off
M - More
Enter Option >
Generic SDI-12 Options
T - Test Address: 0
A - Acknowledge
I - Identify
V - Verify
M - Measure
D - Data Retrieval
S - Send Extended
E - Edit Extended:
P - +12 Vx mode: Always On
Enter Option >
System Setup (B - Back)
T - Time: 05:12:00
D - Date: 08/27/10
S - Sync to GPS: ON
Z - UTC offset (min): 0
I - Site ID: Site_ID
P - Port Setup
C - Configuration Files
R - Reset Defaults
U - Update Firmware
Enter Option >
Serial Port Setup
R - Baud Rate: 9600
F - Flow Control: SW
E - Emulation: VT-100
S - Startup Mode: MENU
Enter Option >
Setup/Update Menu (B - Back)
S - Send Setup Data
F - Setup From File
Enter Option >
Output Options (B - Back)
L - Logging Options
G - GOES Radio Options
Enter Option >
ON
BACK
NOTES: