Bell & Gossett 10 001 265R5 TechnoForce Pump Controller - Manual (Page 7)

TECHNOFORCE Installation, Operation, and Maintenance 1
1. Introduction and Safety
1.1 Introduction
1.1.0 Purpose of the manual
The purpose of this manual is to provide necessary information for:
• Installation
• Operation
• Maintenance
CAUTION:
Read this manual carefully before installing and using the product. Improper use of the product can cause
personal injury and damage to property, and may void the warranty.
NOTICE:
Save this manual for future reference, and keep it readily available at the location of the unit.
The information contained in this manual is intended to assist operating personnel by providing information on
the characteristics of the purchased equipment.
It does not relieve the user of the responsibility to adhere to local codes and ordinances and the use of accepted
practices in the installation, operation and maintenance of this equipment.
Further information pertaining to the installation, operation, and maintenance of your TechnoForce pump
controller can be found in the IOMs for the associated equipment provided Maintenance section for a list of
relevant manuals.
Equipment cannot operate well without proper care. To keep this unit at top efficiency, follow the recommended
installation and servicing procedures outlined in this manual.
1.2 Safety
WARNING:
• The operator must be aware of safety precautions to prevent physical injury.
• Any pressure-containing device can explode, rupture, or discharge its contents if it is
over-pressurized. Take all necessary measures to avoid over-pressurization.
• Operating, installing, or maintaining the unit in any way that is not covered in this manual could
cause death, serious personal injury, or damage to the equipment. This includes any modification
to the equipment or use of parts not provided by Xylem. If there is a question regarding the
intended use of the equipment, please contact an Xylem representative before proceeding.
• This manual clearly identifies accepted methods of disassembling units. These methods must be
adhered to. Trapped liquid can rapidly expand and result in a violent explosion and injury. Never
apply heat to impellers, propellers, or their retaining devices to aid in their removal.
• Do not change the service application without the approval of an authorized Xylem
representative.
1.3 Safety terminology and symbols
1.3.0 About safety messages
It is extremely important that you read, understand, and follow the safety messages and regulations carefully
before handling the product. They are published to help prevent these hazards.
• Personal accidents and health problems
• Damage to the product
• Product malfunction
Introduction and Safety