Bell & Gossett 10 001 265R5 TechnoForce Pump Controller User Manual

Page 23

TECHNOFORCE Installation, Operation, and Maintenance

Installation

To set up each field, press the

NO/0 key and ENTER key. Modify the values as desired using the appropriate

keys. Modify the values as desired for pump 1.
Note: For example, to enter a value of 3.5 Amps, go to the amps field, press numerical key 3 and

press enter. Then press key 5 and enter.
To change the values for other pumps, press the

NEXT/( ) key. This is only applicable if the total numbers of

pumps selected in

TOTAL PUMPS: # field are more than 1.

Note:

All values will be copied to the next screen by pressing

NEXT/( ) key. They will only be copied the first time

the screens are visited. To edit the values, press the

NO/0 key and ENTER key. Modify the values as desired.

To confirm the modified values, press

YES/7 key and then press ENTER key.

The screen will go back to the

PUMP SET UP MENU display.

To change the values in

RESET PUMP TIME field, press the SETUP/3 key then press the ENTER key. The

following menu will get displayed:

RESET PUMP TIME?

P1: N

P2: N

P3: N

P4: N

P5: N

P6: N

OK $ (Y/N)

To reset the pump(s) run time, press

NO/0 key and ENTER.

By default,

N will be displayed next to the pump fields (P1: , P2: etc.) depending upon number of pumps

selected.

N corresponding to P1: field will start blinking. To reset the pump run time for pump 1, press the

YES/7 key and ENTER. Similarly modify the values for the rest of the pumps as applicable.
Note: This selection is only valid for the pumps selected. For example, if the number of pumps selected is 2, the

following screen will get displayed:

RESET PUMP TIME?

P1: N

P2: N

P3: N/A

P4: N/A P5: N/A P6: N/A

OK N (Y/N)

To confirm all the selections made, press

YES/7 key and then press ENTER key. The screen will go back to the

PUMP SET UP MENU display.
Pressing the

NO/0 key and then ENTER key at the PUMP SET UP screen will take the display back to the

MAIN SET UP screen.

4.10.2 System set up

Paths: Status Screens / Set up(3)

Press the

SETUP/3 key at the Main Set Up menu screen. Then press the ENTER key.

The first screen will get displayed as shown below:
< SELECTION: # >
1 = STAGE/DESTAGE
2 = VFD
3 = EXERCISE 0 = EXIT
Press the

NEXT/( ) key to go to the next screen. The display now shows:

< SELECTION: # >
4 = ALTERNATION 5=PID
6 = RESET TOTALS
7 = DATE, TIME 0 = EXIT
Press the

NEXT/( ) key to go to the next screen. The display now shows:

< SELECTION: # >
8 = PASSWORD 0 = EXIT

▲