Bell & Gossett 10 001 265R5 TechnoForce Pump Controller - Manual (Page 12)

TECHNOFORCE Installation, Operation, and Maintenance 6
3. Product Description
3.1 General description
3.1.0 Description
The controller is a specific purpose programmable pump controller. This provides:
• Optimum pump control without the cost of general purpose control hardware.
• Software dedicated and established for the unit.
• Unique analog input protection of other members of the control family. In the event of a short
circuit condition, the current limit circuitry prevents failure of the analog input components.
NOTICE:
• Your controller should have a safety instruction decal. If the decal is missing or illegible, contact
your representative for a replacement.
3.2 Operational limits
3.2.0 Temperature and ventilation
All electrical equipment is susceptible to failure if operated in ambient temperatures outside of its rating. The
OPERATING temperature range for this unit is 0 to 40°C. The relative humidity should not exceed 90% non-
condensing. The unit should not be operated outside these extremes.
3.3 Nameplate information
3.3.0 Important information for ordering
Every pump station has a nameplate that provides information about the pump station. The pump station
nameplate is located on the inside of the control enclosure door.
When ordering spare parts, be prepared to identify the nameplate information when contacting the factory.
• Model
• Size
• Serial number
• Item numbers of the required parts
Product Description
Date Code
Pump Boost
Discharge Pressure
Suction Pressure
Station Flow
Largest Motor HP
SCCR
System FLA
Station Voltage
Serial Number
Model Number
Residential & Commercial Water
Dallas, Texas, U.S.A
.