14 program type and version number – Bell & Gossett 10 001 265R5 TechnoForce Pump Controller User Manual
Page 56
TECHNOFORCE Installation, Operation, and Maintenance
50
Maintenance
6.14 Program type and version number
To check the program type and version number, press the
INFO/8 key while at the Pump Controller status
screen.
The screen will now display:
Sys Info CPU V ###
AS V ###
OS ####
Prog Type: #####
Scheme No: # SW# ##
Press the
CLEAR key to exit this screen.
The # symbol will be replaced by the actual version numbers and program type. If the factory is called for
information or service on this unit this information may be requested.
6.14.0 Log menu
To view the
LOG MENU, press the LOG/5 key while at the Status Screens.
The
LOG MENU screen will be displayed as shown below:
1 = ALARM LOG
2 = PUMP LOG
3 = DATA LOG 0 = EXIT
NEXT/( ) key to go to the next screen. The display now shows:
4 = OPERATION
5 = SERVICE LOG 0 = EXIT
ENTER key. A detailed description
of each menu follows. For example
6.14.1 Alarm log
Paths: Status Screens / Log(5)/Alarm Log(1)
The display now shows:
MMDD HHMM alarm message
MMDD HHMM alarm message
MMDD HHMM alarm message
MMDD HHMM alarm message
Every alarm that occurs will be logged with a date and time stamp. The forty most recent alarms will be stored.
The date is displayed in MMDD format and the time in 24 hour HHMM format. The most recent alarm is
shown first. Press
NEXT/( ) and PREV/( ) view more log events. Press CLEAR to exit.
6.14.2 Pump log menu
Paths: Status Screens / Log(5)/Pump Log(2)
The display now shows:
Selection: # 0=Exit
1=Pump Log
2=Pump Run Time
3=Pump On/Off Times
Use the appropriate numeric key to select the desired sub-menu, then press the
ENTER key.
A detailed description of each sub-menu appears.
▲
▲
▲