Bell & Gossett 10 001 265R5 TechnoForce Pump Controller User Manual

Page 60

TECHNOFORCE Installation, Operation, and Maintenance

Maintenance

6.14.16 Events

Paths: Status Screens / Log(5) / Operation(4) / Events(3) / Events(4)
The display now shows:
MMDD HHMM Event Message
MMDD HHMM Event Message
MMDD HHMM Event Message
MMDD HHMM Event Message
Every time an event occurs, it gets logged. The forty most recent logs will be stored. The date is displayed

in MMDD format and the time in 24 hour HHMM format. The most recent event will be shown first. Press

NEXT/( ) and PREV/( ) to view more log events. Press CLEAR to exit.

6.14.17 VFD

Paths: Status Screens / Log(5) / Operation(4) / VFD(4)
The display now shows:
MMDD HHMM VFD Failure Message
MMDD HHMM VFD Failure Message
MMDD HHMM VFD Failure Message
MMDD HHMM VFD Failure Message
Every time VFD failure occurs, it gets logged. The forty most recent logs will be stored. The date is displayed

in MMDD format and the time in 24 hour HHMM format. The most recent event will be shown first. Press

NEXT/( ) and PREV/( ) to view more log events. Press CLEAR to exit.

6.14.18 Exercise

Paths: Status Screens / Log(5) / Operation(4) / Exercise(5)
The display now shows:
MMDD HHMM Pump #
MMDD HHMM Pump #
MMDD HHMM Pump #
MMDD HHMM Pump #
Every time a pump is exercised, it gets logged. The forty most recent logs will be stored. The date is displayed

in MMDD format and the time in 24 hour HHMM format. The most recent event will be shown first. Press

NEXT/( ) and PREV/( ) to view more log events. Press CLEAR to exit.

6.14.19 Set Point

Paths: Status Screens / Log(5) / Operation(4) / Set Point(6)
The display now shows:
MMDD HHYY Set point change message
MMDD HHYY Set point change message
MMDD HHYY Set point change message
MMDD HHYY Set point change message
Every time setpoint change, it gets logged. The forty most reset logs will be stored. the date is displayed in

MMDD format and the time in 24 hour HHMM format. The most resent event will be shown first. Press

NEXT/( ) and PREV/( ) to view more log events. Press CLEAR to exit.

▲