Bell & Gossett 10 001 265R5 TechnoForce Pump Controller User Manual
Page 36
TECHNOFORCE Installation, Operation, and Maintenance
30
4.10.26 Load from flash
The Load From Flash screen is displayed below:
LOAD FROM FLASH
All Settings will be
Overwritten!
PROCEED: $ (Y/N)
Press
YES/7 and ENTER to overwrite all of the current user setup information with the data that was
previously saved to the flash memory. Loading from flash memory will load all setup information that was saved
to the Flash PROM chip within the controller.
4.10 27 Load default
The Load Default screen is displayed below:
LOAD DEFAULTS
Settings will be
Overwritten by the
defaults! PROCEED:$(Y/N)
Press
YES/7 and ENTER to overwrite all of the current user setup information with the factory defaults.
4.10.28 Display menu
Paths: Status Screens / Set up(3) / System(3) / Display(13)
The DISPLAY menu has been shown below:
Delay to Display
Status # m
Rate ##s Exit $(Y/N)
Press the next ( ) key to go to the next screen. The display now shows:
Exit $ (Y/N)
NO/0 key and ENTER key. Modify the values as desired.
See following table for all
DISPLAY menu items.
Display Menu Items
Menu Item
Variable
Default Range Field
Value
Display
Delay to Display Status: ##
3
0-99
The time in minutes after which the fourth line at initial
system status screen will start showing system status if
any key has not been pressed
Status Line Refresh Rate: ##
10
0-99
The time in seconds prior to change the next system
status line
The time in minutes after which the backlight display
60
0-999
will turn off if a key has not been pressed. A value of 0
displays this function.
Installation
▲