B&B Electronics EIRP610-2SFP-T - Manual - Manual (Page 48)

Web-Based Management
6.8 System Event Log
This page allows the user to decide whether to send the system event log, and select the mode
which the system event log will be sent to client only, server only, or both client and server.
What kind of event log will be issued to the client/server depends on the selection on the Event
Configuration tab. There are five types of event—Device Cold Start, Device Warm Start,
Authentication Failure, X-Ring Topology Change, and Port Event—available to be issued as
the event log.
6.8.1 Syslog Configuration
 Syslog Client Mode: Select the system log mode—Client Only, Server Only, or Both.
‗Client Only‘ means the system event log will only be sent to this interface of the switch,
but on the other hand ‗Server Only‘ means the system log will only be sent to the remote
system log server with its IP assigned. If the mode is set in ‗Both‘, the system event log will
be sent to the remote server and this interface.
 System Log Server IP Address: When the ‗Syslog Mode‘ item is set as Server Only/Both,
the user has to assign the system log server IP address to which the log will be sent.
 Click Reload to refresh the event log displaying area.
 Click Clear to clear all the current event logs.
 Make sure the selected mode is correct, and click
Apply to have the setting take effect.
42 Manual Documentation Number EIRP610-2SFP-T – 0912m
www.bb-elec.com
www.bb-europe.com