B&B Electronics EIRP610-2SFP-T - Manual - Manual (Page 133)

Command Sets
Netstar Commands Level Description Example
(BPDU) message from
the root switch within
this interval, it
recomputed the
Spanning Tree Protocol
(STP) topology.
spanning-tree hello-time
[seconds]
G Use the spanning-tree
hello-time global
configuration command
to specify the interval
between hello bridge
protocol data units
(BPDUs).
switch(config)#spanning-tree hello-
time 3
spanning-tree forward-
time [seconds]
G Use the spanning-tree
forward-time global
configuration command
to set the forwarding-
time for the specified
spanning-tree instances.
The forwarding time
determines how long
each of the listening and
learning states last
before the port begins
forwarding.
switch(config)#spanning-tree
forward-time 20
stp-path-cost
[1~200000000]
I Use the spanning-tree
cost interface
configuration command
to set the path cost for
Spanning Tree
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-cost 20
127 Manual Documentation Number EIRP610-2SFP-T – 0912m
www.bb-elec.com
www.bb-europe.com