Trunk commands set – B&B Electronics EIRP610-2SFP-T - Manual User Manual
Page 129
Command Sets
Trunk Commands Set
Netstar Commands
Level Description
Example
aggregator priority
[1~65535]
G
Set port group system
priority
switch(config)#aggregator priority
22
aggregator activityport
[Group ID]
[Port Numbers]
G
Set activity port
switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp workp
[Workport]
G
Assign a trunk group
with LACP active.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The amount
of work ports, this value
could not be less than
zero or be large than the
amount of member ports.
switch(config)#aggregator group 1
1-4 lacp workp 2
or
switch(config)#aggregator group 2
1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator group 1
2-4 nolacp
or
switch(config)#aggregator group 1
3,1,2 nolacp
123
Manual Documentation Number EIRP610-2SFP-T
– 0912m