B&B Electronics EIRP610-2SFP-T - Manual User Manual
Page 134
Command Sets
Netstar Commands
Level Description
Example
Protocol (STP)
calculations. In the event
of a loop, spanning tree
considers the path cost
when selecting
an interface to place into
the forwarding state.
stp-path-priority
[Port Priority]
I
Use the spanning-tree
port-priority interface
configuration command
to configure a port
priority that
is used when two
switches tie for position
as the root switch.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-priority
128
stp-admin-p2p
[Auto|True|False]
I
Admin P2P of STP
priority on this interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-p2p
Auto
stp-admin-edge
[True|False]
I
Admin Edge of STP
priority on this interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-edge
True
stp-admin-non-stp
[True|False]
I
Admin NonSTP of STP
priority on this interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-non-stp
False
show spanning-tree
E
Displays a summary of
the spanning-tree states.
switch>show spanning-tree
128
Manual Documentation Number EIRP610-2SFP-T
– 0912m