B&B Electronics EIRP610-2SFP-T - Manual User Manual
Page 128
Command Sets
Netstar Commands
Level Description
Example
and zero means no limit.
show bandwidth
I
Show interfaces
bandwidth control
switch(config)#interface
fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I
Use the state interface
configuration command
to specify the state mode
of operation for Ethernet
ports. Use the disable
form of this command to
disable the port.
switch(config)#interface
fastEthernet 2
switch(config-if)#state Disable
show interface
configuration
I
show interface
configuration status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
show interface status
I
show interface actual
status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
status
show interface accounting
I
show interface statistic
counter
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
accounting
no accounting
I
Clear interface
accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
122
Manual Documentation Number EIRP610-2SFP-T
– 0912m