B&B Electronics EIRP610-2SFP-T - Manual - Manual (Page 146)

Command Sets
Netstar Commands Level Description Example
[Minute] saving time, if SNTP
function is inactive, this
command can‘t be
applied.
sntp ip
[IP]
G Set SNTP server IP, if
SNTP function is
inactive, this command
can‘t be applied.
switch(config)#sntp ip 192.169.1.1
sntp timezone
[Timezone]
G Set timezone index, use
―show sntp timzezone‖
command to get more
information of index
number
switch(config)#sntp timezone 22
show sntp P Show SNTP information switch#show sntp
show sntp timezone P Show index number of
time zone list
switch#show sntp timezone
no sntp G Disable SNTP function switch(config)#no sntp
no sntp daylight G Disable daylight saving
time
switch(config)#no sntp daylight
X-ring Commands Set
Netstar Commands Level Description Example
ring enable G Enable X-ring switch(config)#ring enable
ring master G Enable ring master switch(config)#ring master
ring couplering G Enable couple ring switch(config)#ring couplering
ring dualhoming G Enable dual homing switch(config)#ring dualhoming
ring ringport G Configure 1st/2nd Ring switch(config)#ring ringport 7 8
140 Manual Documentation Number EIRP610-2SFP-T – 0912m
www.bb-elec.com
www.bb-europe.com