B&B Electronics EIRP610-2SFP-T - Manual - Manual (Page 145)

Command Sets
Netstar Commands Level Description Example
no event authentication-
failure
G Disable Authentication
failure event typ
switch(config)#no event
authentication-failure
no event ring-topology-
change
G Disable X-ring topology
changed event type
switch(config)#no event ring-
topology-change
no event systemlog I Disable port event for
system log
switch(config)#interface fastethernet
3
switch(config-if)#no event systemlog
no event smpt I Disable port event for
SMTP
switch(config)#interface fastethernet
3
switch(config-if)#no event smtp
show systemlog P Show system log client
& server information
switch#show systemlog
SNTP Commands Set
Netstar Commands Level Description Example
sntp enable G Enable SNTP function switch(config)#sntp enable
sntp daylight G Enable daylight saving
time, if SNTP function is
inactive, this command
can‘t be applied.
switch(config)#sntp daylight
sntp daylight-period
[Start time] [End time]
G Set period of daylight
saving time, if SNTP
function is inactive, this
command can‘t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp daylight-period
20060101-01:01 20060202-01:01
sntp daylight-offset G Set offset of daylight switch(config)#sntp daylight-offset 3
139 Manual Documentation Number EIRP610-2SFP-T – 0912m
www.bb-elec.com
www.bb-europe.com