Grain Systems PNEG-707GSI - Manual (Page 226)

21. Hopper
226 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Hopper (Cross Section) Example - All Models (Continued)
Figure 21Q While installing outside hopper panels,
allow ends to overlap at center of dryer.
Figure 21R Close Up - Bolting outside hopper
panels (R.H./L.H.). Lap outside hopper panels-R.H.
with cut out (arrow) on outside of dryer so slide
gate will slide freely.
A. Bolt flat edges together.
B. Angled edges will bolt together later, under
hopper channel with common bolt.
Figure 21S Installing outside hopper panels.
Figure 21T Bring metering drum floor into outside
hopper before closing in with last panel.
Figure 21U
IMPORTANT: After all outside hopper panels are in
place, secure against wind with
temporary bolts, especially overnight.
Figure 21V Aligning outside hopper panels before
installing hopper discharge weldment.
A
B