Grain Systems PNEG-707GSI - Manual (Page 178)

16. Fan Motors
178 PNEG-707 12', 18', 24' and 30' GSI Commercial Tower Dryer
Fan Motors
Install fan motor to each fan motor mount as follows.
Lift or lower dryer as necessary to install fan motors.
1. Attach lifting tackle to fan motor. (See Figure 16H.) Lift fan motor onto fan motor mount, with drive
shaft up.
2. Bolt fan motor to fan motor mount in bolt holes appropriate to motor size.
May be necessary to lift dryer to insert bolts.
Use 5/8" x 2" bolts, nuts and washers from standard hardware kit.
Figure 16H Attach lifting tackle to fan motor.
Figure 16I Moving fan motor to fan motor mount.
Figure 16J Bolting fan motor to fan motor mount.
Figure 16K Fan motors installed to fan motor mounts.