beautypg.com

2 how stp works, 3 stp port states, 2 how stp works 11.1.3 stp port states – ZyXEL Communications GS-4012F/4024 User Manual

Page 99: Table 22 stp port states

background image

GS-4012F/4024 User’s Guide

98

Chapter 11 Spanning Tree Protocol

On each bridge, the root port is the port through which this bridge communicates with the root.
It is the port on this switch with the lowest path cost to the root (the root path cost). If there is
no root port, then this switch has been accepted as the root bridge of the spanning tree
network.

For each LAN segment, a designated bridge is selected. This bridge has the lowest cost to the
root among the bridges connected to the LAN.

11.1.2 How STP Works

After a bridge determines the lowest cost-spanning tree with STP, it enables the root port and
the ports that are the designated ports for connected LANs, and disables all other ports that
participate in STP. Network packets are therefore only forwarded between enabled ports,
eliminating any possible network loops.

STP-aware switches exchange Bridge Protocol Data Units (BPDUs) periodically. When the
bridged LAN topology changes, a new spanning tree is constructed.

Once a stable network topology has been established, all bridges listen for Hello BPDUs
(Bridge Protocol Data Units) transmitted from the root bridge. If a bridge does not get a Hello
BPDU after a predefined interval (Max Age), the bridge assumes that the link to the root
bridge is down. This bridge then initiates negotiations with other bridges to reconfigure the
network to re-establish a valid network topology.

11.1.3 STP Port States

STP assigns five port states to eliminate packet looping. A bridge port is not allowed to go
directly from blocking state to forwarding state so as to eliminate transient loops.

Path Cost 16Mbps

62

40 to 400

1 to 65535

Path Cost 100Mbps

19

10 to 60

1 to 65535

Path Cost 1Gbps

4

3 to 10

1 to 65535

Path Cost 10Gbps

2

1 to 5

1 to 65535

Table 21 STP Path Costs

LINK SPEED RECOMMENDED VALUE

RECOMMENDED
RANGE

ALLOWED RANGE

Table 22 STP Port States

PORT STATE DESCRIPTION

Disabled

STP is disabled (default).

Blocking

Only configuration and management BPDUs are received and processed.

Listening

All BPDUs are received and processed.