12 name, 13 speed-duplex, 14 test – ZyXEL Communications GS-4012F/4024 User Manual
Page 318: 12 name 45.2.13 speed-duplex 45.2.14 test
GS-4012F/4024 User’s Guide
Chapter 45 Interface Commands
317
45.2.12 name
Syntax:
name
where
An example is shown next.
• Enable port one for configuration.
• Set a name for the port.
45.2.13 speed-duplex
Syntax:
speed-duplex
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the speed to 100 Mbps in half duplex mode.
45.2.14 test
You can perform an interface loopback test on specified ports. The test returns
Passed!
or
Failed!
=
Sets a name for your port interface.
sysname(config)# interface port-channel 1
sysname(config-interface)# name Test
full|1000-full>
=
Sets the duplex mode (half or full) and speed (10, 100 or 1000
Mbps) of the connection on the port. Selecting auto (auto-
negotiation) makes one port able to negotiate with a peer
automatically to obtain the connection speed and duplex mode
that both ends support.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# speed-duplex 100-half