ZyXEL Communications GS-4012F/4024 - Manual (Page 328)

GS-4012F/4024 User’s Guide
Chapter 47 Multicast VLAN Registration Commands 327
C
H A P T E R
47
Multicast VLAN Registration
Commands
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.
47.1 Overview
Use the mvr commands in the configuration mode to create and configure multicast VLANs.
Note: If you want to enable IGMP snooping see Section 44.1 on page 299 .
47.2 Create Multicast VLAN
Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr
mvr source-port
mvr receiver-port
mvr inactive
mvr mode
mvr name
mvr tagged
mvr group start-address end-address
mvr exit
where
= The VLAN ID [1 – 4094].
source-port
= Specifies the MVR source ports which send and receive multicast
traffic.
receiver-port
= Specifies the MVR receiving ports which only receive multicast
traffic.
name = A name to identify the multicast VLAN group.
mode
ble> = Specifies dynamic (sends IGMP reports to all source ports in the
multicast VLAN) or compatible (does not send IGMP reports).