ZyXEL Communications GS-4012F/4024 - Manual (Page 307)

GS-4012F/4024 User’s Guide
306 Chapter 44 Configuration Mode Commands
• Disable the secure shell RSA1 encryption key.
• Remove the remote host with IP address 172.165.1.8 from the list of known hosts.
• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
44.5 Static Route Commands
You can create and configure static routes on the switch by using the ip route command.
Syntax:
ip route
ip route [metric ][name ]
--> [inactive]
where
An example is shown next.
• Create a static route with the destination IP address of 172.21.1.104, subnet mask of
255.255.0.0 and the gateway IP address of 192.168.1.2.
• Assigns a metric value of 2 to the static route.
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
= Specifies the network IP address of the final destination.
= Specifies the subnet mask of this destination.
= Specifies the IP address of the gateway. The gateway is an
immediate neighbor of your switch that will forward the
packet to the destination. The gateway must be a router on
the same segment as your switch.
[metric ] = The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and
15. In practice, 2 or 3 is usually a good number.
[name ] = Specifies a descriptive name (up to 32 printable ASCII
characters) for identification purposes.
[inactive] = Deactivates a static route