ZyXEL Communications GS-4012F/4024 - Manual (Page 313)

GS-4012F/4024 User’s Guide
312 Chapter 45 Interface Commands
where
An example is shown next.
• Enable ports 1, 3, 4 and 5 for configuration.
• Set the BPDU control to
tunnel , to forward BPDUs received on ports one, three, four
and five.
45.2.3 broadcast-limit
Syntax:
broadcast-limit
broadcast-limit
where
An example is shown next.
• Enable port one for configuration.
• Enable broadcast control.
• Set how many broadband packets the interface receives per second.
45.2.4 bandwidth-limit
The bandwidth-limit command enables bandwidth control on the switch.
network> = Type peer to process any BPDUs received on these ports.
Type tunnel to forward BPDUs received on these ports.
Type discard to drop any BPDUs received on these ports.
Type network to process a BPDU with no VLAN tag and
forward a tagged BPDU.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# bpdu-control tunnel
sysname(config-interface)#
= Enables broadcast storm control limit on the switch.
= Limits how many broadcast packet the interface receives per second.
sysname(config)# interface port-channel 1
sysname(config-interface)# broadcast-limit
sysname(config-interface)# broadcast-limit 21