ZyXEL Communications GS-4012F/4024 - Manual (Page 330)

GS-4012F/4024 User’s Guide
Chapter 48 Routing Domain Command Examples 329
C
H A P T E R
48
Routing Domain Command
Examples
48.0.1 interface route-domain
Syntax:
interface route-domain /
where
Use this command to enable/create the specified routing domain for configuration.
An example is shown next.
• Enter the configuration mode.
• Enable default routing domain (the 192.168.1.1 subnet) for configuration.
• Begin configuring for this domain.
= This is the IP address of the switch in the routing domain. Specify the IP
address is dotted decimal notation. For example, 192.168.1.1.
= The number of bits in the subnet mask. Enter the subnet mask number
preceded with a “/”. To find the bit number, convert the subnet mask to
binary and add all of the 1’s together. Take “255.255.255.0” for
example. 255 converts to eight 1’s in binary. There are three 255’s, so
add three eights together and you get the bit number (24).
sysname# config
sysname(config)# interface route-domain 192.168.1.1/24
cmd interface route domain
192.168.1.1 255.255.255.0
sysname(config-if)#