beautypg.com

2 vrrp parameters, 1 advertisement interval, 2 priority – ZyXEL Communications GS-4012F/4024 User Manual

Page 204: 3 preempt mode, 3 configuring vrrp parameters

background image

GS-4012F/4024 User’s Guide

Chapter 31 VRRP

203

31.3.2 VRRP Parameters

This section describes the VRRP parameters.

31.3.2.1 Advertisement Interval

The master router sends out Hello messages to let the other backup routers know that it is still
up and running. The time interval between sending the Hello messages is the advertisement
interval. By default, a Hello message is sent out every second.

If the backup routers do not receive a Hello message from the master router after this interval
expires, it is assumed that the master router is down. Then the backup router with the highest
priority becomes the master router.

Note: All routers participating in the virtual router must use the same advertisement

interval.

31.3.2.2 Priority

Configure the priority level (1 to 254) to set which backup router to take over in case the
master router goes down. The backup router with the highest priority will take over. The
priority of the VRRP router that owns the IP address(es) associated with the virtual router is
255.

31.3.2.3 Preempt Mode

If the master router is unavailable, a backup router assumes the role of the master router.
However, when another backup router with a higher priority joins the network, it will preempt
the lower priority backup router that is the master. Disable preempt mode to prevent this from
happening.

By default, a layer 3 device with the same IP address as the virtual router will become the
master router regardless of the preempt mode.

31.3.3 Configuring VRRP Parameters

After you set up an IP interface, configure the VRRP parameters in the VRRP Configuration
screen.

Apply

Click Apply to save your changes to the switch’s run-time memory. The switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the non-volatile memory when you are done

configuring.

Cancel

Click Cancel to discard all changes made in this table.

Table 78 VRRP Configuration: IP Interface (continued)

LABEL

DESCRIPTION