ZyXEL Communications GS-4012F/4024 - Manual (Page 309)

GS-4012F/4024 User’s Guide
308 Chapter 44 Configuration Mode Commands
44.7 Enabling Trunking
To create and enable a trunk, enter trunk followed by the ports which you want to group and
press [ENTER]
.
Syntax:
trunk
trunk interface
trunk lacp
where
An example is shown next.
• Create trunk 1 on the switch.
• Place ports 5-8 in trunk 1.
• Enable dynamic link aggregation (LACP) on trunk 1.
44.8 Enabling Port Authentication
To enable a port authentication, you need to specify your RADIUS server details and select the
ports which require external authentication. You can set up multiple RADIUS servers and
specify how the switch will process authentication requests.
44.8.1 RADIUS Server Settings
Configuring multiple RADIUS servers is only available via the command interpreter mode.
Use the
radius-server command to set up your RADIUS server settings.
Syntax:
radius-server host
radius-server host [acct-port ] [key
--> ]
radius-server timeout <1-1000>
radius-server mode
= Enables the trunk.
interface = Places ports in the trunk.
lacp = Enables LACP in the trunk.
sysname(config)# trunk t1
sysname(config)# trunk t1 interface 5-8
sysname(config)# trunk t1 lacp