ZyXEL Communications GS-4012F/4024 - Manual (Page 79)

GS-4012F/4024 User’s Guide
78 Chapter 7 Basic Setting
7.7 Port Setup
Use this screen to configure switch port settings.Click Basic Setting and then Port Setup in
the navigation panel to display the configuration screen.
Figure 32 Port Setup
The following table describes the labels in this screen.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out from the switch.
Cancel Click Cancel to clear the Delete check boxes.
Table 11 IP Setup (continued)
LABEL DESCRIPTION
Table 12 Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.