ZyXEL Communications GS-4012F/4024 - Manual (Page 287)

GS-4012F/4024 User’s Guide
286 Chapter 42 Introducing Commands
ingress-check Disables ingress checking on the
port(s).
13
intrusion-lock Disables intrusion-lock on a port so
that a port can be connected again
after you disconnected the cable.
13
ipmc egress-
untag-vlan
Disables the port(s) from removing
specified VLAN tag from IP
multicasting packets before
forwarding.
13
mirror Disables port mirroring on the
port(s).
13
multicast-limit Disables multicast limit on the
port(s).
13
vlan-trunking Disables VLAN trunking on the
port(s).
13
pvid The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1
to 4094 for the specified interface.
13
qos priority <0 ..
7>
Sets the quality of service priority
for an interface.
13
speed-duplex
half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode ( half or
full ) and speed ( 10 , 100 or
1000 Mbps) of the connection on
the interface. Selecting auto
(auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
13
spq Sets the port(s) to use Strict
Priority Queuing.
13
vlan-stacking priority <0-7> Sets the priority of the specified
port(s) in VLAN stacking.
13
role
tunnel>
Sets the VLAN stacking port roles
of the specified port(s).
13
SPVID Sets the service provider VID of
the specified port(s).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
switch.
13
weight
...
A weight value of one to eight is
given to each variable from wt 1 to
wt 8.
13
wrr Sets the port(s) to use Weighted
Round Robin queuing.
13
Table 107 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE