Xerox 4090 - Manual (Page 65)

PRINTING JOBS
Enter JOBS ALL FULL to display the reports being held in the
queue. An asterisk appears next to the attribute that is causing
the job to be held. Using this information, take the appropriate
corrective action: change the color dry ink, substitute inks,
disable stitching, and so forth.
Resuming an interrupted print job
If a print job has been interrupted, either by you, by the
software, or by a condition such as a misfeed or low paper, use
the CONTINUE command when you are ready to resume. This
section describes the variations of this command.
CONTINUE command If you enter the CONTINUE command, the following message
display:
OS0010 Resuming INPUT
OS0020 Resuming OUTPUT
Both input and printing resume.
CONTINUE I command If you enter the CONTINUE I command, the following message
displays:
OS0010 Resuming INPUT
Input resumes, but printing does not.
CONTINUE O command If you enter the CONTINUE O command, the following message
displays:
OS0020 Resuming OUTPUT
Printing resumes, but input does not.
key If you press , both input and printing resume, as if you
entered the CONTINUE command.
Continue button If you press the Continue button on the printer control console,
only printing resumes, not input. Pressing the Continue button
acts as a CONTINUE O command.
Stopping a HIP print job
To stop HIP from submitting jobs for processing, enter the
following command:
HIP STOP
Jobs already submitted for processing are not affected.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE 4-13