Xerox 4090 - Manual (Page 126)

SOLVING PROBLEMS
Follow these steps to clear area 4:
1. If there is a jam in both areas 4 and 5, clear area 5 first.
2. With your left hand, move and hold the green latch to the
right (the direction of the arrow marked on it). With your
right hand, pull out the large green handle until the fuser unit
latches in the fully open position.
3. Raise the small green handle at the front of the fuser
assembly.
WARNING: Parts of this area are hot enough to cause some
discomfort after prolonged contact. Exercise caution.
4. Remove and discard any paper found in this area.
CAUTION: Do not use a sharp object to remove paper
wrapped around the fuser rolls. Attempting to do so could
damage the roller and require its replacement.
5. Return the small green handle to its original position.
8-8 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE