Xerox 4090 - Manual (Page 52)

SETTING UP PRINT JOB SOURCES
Note: You may find that HIP is stopped. In that case, enter HIP
STA or HIP START. The system responds with
OS1000 READY FOR
COMMANDS.
Taking HIP offline
To take HIP offline and stop it from accepting files from the host,
enter HIP OFFLINE.
The system response is delayed to the end of the current file if a
file is being transmitted. The following messages display:
HP1200 OFFLINE pending End Of Transmission.
HP1207 OFFLINE pending end of current active XNS session.
HP1230 HOST OFFLINE.
The following are reasons the message
HP1230 HOST OFFLINE
occurs:
• If an XNS transmission error occurs, the HIP requests
retransmission of data starting with the data packet following
the last successfully received packet. If the packet cannot be
successfully retransmitted, the request is aborted and the
session with the client is terminated.
• The HIP also terminates an XNS session (and aborts a print
request if one is in progress for that session) if it is expecting
data from a client but has not received a packet from that
client in 40 seconds.
• If HIP has not received a packet within 60 seconds after the
last packet was received, it attempts to determine if an
interface problem exists. To do this, it broadcasts requests
for Clearinghouse and Time servers on the net. If HIP does
not receive any responses, it assumes an interface problem
has occurred. To correct this problem, HIP takes the
interface offline (to reset the controller) and attempts (up to
five times) to bring the interface back online.
3-24 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE