Xerox 4505/4505ps - Manual (Page 45)

S e l e c t i n g a P a p e r S o u r c e
C h a p t e r 2 : H a n d l i n g P a p e r ❖ 2-33
You do not have a lower base installed. You want to use
pre-printed stationery for the first page and regular stock for
the other pages of your document. Your software application
has the capability to ask for the first page of a document from
a different source than the remainder of the document. The
Xerox PCL 5e emulation Windows printer driver also has this
capability . It is assumed your pre-printed stationery is the
same size as your regular stock.
1. Load the standard tray with regular paper stock.
2. Load the MP tray with pre-printed stationery (face down).
3. Set Source Mapping for “Standard” to “Standard.”
4. Set Source Mapping for “Lower” to “MP Tray.”
5. Set MP Tray Size to the same size as your pre-printed
stationery.
6. In either your software application or the Xerox PCL 5e
emulation Windows printer driver, set paper source for
the first page to Lower and set paper source for the
remaining pages to Standard.
The printer will pull the first page from the MP tray and all
other pages from the standard tray.
Alternatively, you could substitute any paper source, except
standard, for “Lower” in the fourth and sixth steps above.
Refer to the Document Services for Printing Guide for more
information about the printer driver.
Example 7
Note
AUG-CH02 Page 33 Black,Red,Cyan Tuesday, March 21, 1995 5:06 PM