Xerox 4505/4505ps - Manual (Page 114)

P r i n t e r S e t t i n g s t h a t A f f e c t M e m o r y
3-68 ❖ 4 5 0 5 / 4 5 0 5 p s o r 4 5 1 0 / 4 5 1 0 p s U s e r ’ s G u i d e
Jam Recovery
PCL Menu (page 3-26)
PostScript Menu (page 3-35)
A paper jam may cause a page image being printed to become lost. When
Jam Recovery is On , the printer will automatically reprint the image of the
jammed page, after the jam has been cleared.
Because the printer holds a page image in memory longer with Jam
Recovery , if a low memory condition occurs there can be a slight
performance impact and the printer may require more memory. If sufficient
memory exists,
Jam Recovery has no impact.
Resolution
PCL Menu (page 3-27)
PostScript Menu (page 3-35)
The printer prints at 600 or 300 dpi. The factory setting is 600 dpi.
Your software application may be able to set Resolution and override the
setting here. Whether a new Resolution is set by your application or on
the Control Panel, the new Resolution becomes effective with the next
print job or with a printer reset. Unless State Saving (page 3-28 for PCL,
page 3-36 for PostScript, and page 3-68) is On , downloaded fonts and
macros may be cleared from memory.
The higher the resolution, the more memory required. See Figure 3.26
(page 3-69) for memory requirements.
State Saving
PCL Menu (page 3-28)
PostScript Menu (page 3-36)
When State Saving is Off , fonts and printer macros permanently
downloaded from your software application are cleared from memory
when:
• The printer switches from one page description language (PDL) to
another (such as from PostScript to PCL).
• A memory reconfiguration takes place (such as for a new Page
Protection or Resolution setting).
When State Saving is On , the printer reserves memory to retain the
downloaded fonts and macros. Thus, the fonts and macros do not have to
be downloaded to memory again when switching PDLs or reconfiguring
memory.
You may set State Saving separately for the PCL and the PostScript
environments.
The printer requires 10 MB of memory to enable State Saving when
PostScript is installed. If PostScript is not installed, State Saving may be
enabled with 6 MB of memory.
Figure 3.25 PCL and PostScript Menu options that affect printing speed and memory usage
Option Description
AUG-CH03 Page 68 Black,Red,Cyan Friday, February 3, 1995 12:22 AM