Xerox 4505/4505ps - Manual (Page 44)

S e l e c t i n g a P a p e r S o u r c e
2-32 ❖ 4 5 0 5 / 4 5 0 5 p s o r 4 5 1 0 / 4 5 1 0 p s U s e r ’ s G u i d e
You have a lower base (with either a universal tray or an A4
tray) installed, and you have a DL envelope tray—see
Figure 2.6 (page 2-10) . You want to print mostly on white A4
paper but sometimes on DL envelopes. Occasionally, you
print on color or pre-printed A4 paper.
1. Load the lower tray with white A4 paper stock.
2. Insert the DL envelope tray, filled with DL envelopes, in
the standard paper source.
3. Load the MP tray with color or pre-printed A4 paper stock
(face down).
4. Set Source Mapping for “Standard” to “MP Tray.”
5. Set Source Mapping for “Lower” to “Lower.”
6. Set Source Mapping for “Manual” and “Manual
Envelope” to “Standard.”
7. Set MP Tray Size to “A4 (210x297).”
8. Set Default Source to “Lower” to cover print jobs that do
not contain a paper source selection.
9. In either your application or the Xerox printer driver, set
paper source to:
— Lower tray for white A4 pages.
— Standard tray for color or pre-printed A4 pages.
— Manual for DL envelopes.
Because of the Source Mapping settings in steps 4-6, above,
the printer will pull white A4 paper from the lower tray. It will
pull DL envelopes from the standard tray. It will pull color or
pre-printed A4 pages from the MP tray.
Make sure there is one sheet of A4 stationery in the MP tray
each time you print this document.
Example 6
AUG-CH02 Page 32 Black,Red,Cyan Tuesday, March 21, 1995 5:06 PM