Xerox 4505/4505ps - Manual (Page 105)

S y s t e m M e n u
C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-59
Auto Continue Off*
On
Control of the resumption of printing after system
errors occur.
Certain errors may occur that halt printer operations.
Two examples are:
Out of Memory
and
Page Too Complex .
When Auto Continue is Off , the printer does not
automatically resume. Enter must be pressed
before normal printer operations can continue.
When Auto Continue is On , the printer automatically
resumes operation after certain system errors if
Enter is not pressed within ten seconds . The
On setting is useful in a networked environment .
Print Density
Note: This option is
available for firmware
release 4.0 only. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
0 - 4 ( 2* ) Darkness of the print.
0 is the lightest and 4 is the darkest.
A darker print density uses more toner and may
reduce the life of the EP cartridge.
Figure 3.20 System Menu options showing factory settings (continued)
Option Setting Description
AUG-CH03 Page 59 Black,Red,Cyan Friday, February 3, 1995 12:22 AM