Xerox 4505/4505ps - Manual (Page 171)

D i s p l a y e d C o n t r o l P a n e l M e s s a g e s
C h a p t e r 7 : T r o u b l e s h o o t i n g ❖ 7-5
Control Panel messages are listed in alphabetical order in
Figure 7.2, preceded by numerical diagnostic error codes.
Not listed are the Control Panel menu options, settings, or
functions covered in Chapter 3: Using the Control Panel .
Some two-line messages are separated by the top line and
bottom line. In these instances, look up each line of the
message separately.
In Figure 7.2, “ ACTION ” indicates what you must do to
respond to or clear the message.
You might see a five digit number in the lower right of the
Control Panel. Five-digit codes are for use by manufacturing
and service centers only. The user can ignore five-digit codes.
Figure 7.2 Control Panel messages
Message Description/Action
0001 †
† Appears in the top left
side of the display.
Indicates which module
failed.
The main controller board has failed.
ACTION: Replace controller, or contact your dealer or Xerox / Rank Xerox.
0040 †
† Appears in the top left
side of the display.
Indicates which module
failed.
A PostScript checksum error has occurred.
ACTION: The PostScript card has failed and needs to be replaced.
0100 †
† Appears in the top left
side of the display.
Indicates which module
failed.
SIMM in slot 0 has failed.
ACTION: Move the SIMM to Slot 1; see “Installing a SIMM” (page 5-4) . If a
memory error (0101) occurs again, replace the SIMM. If there is no error, the main
controller board has failed. Contact your dealer or Xerox / Rank Xerox.
Displayed
Control Panel
Messages
Note
AUG-CH07 Page 5 Black,Cyan Friday, February 3, 1995 12:34 AM