ZyXEL Communications 802.11g HomePlug AV ADSL2+ Gateway P-660HWP-Dx - Manual (Page 372)

Appendix G Firewall Commands
P-660HWP-Dx User’s Guide
38
Config edit firewall set #> tcp-idle-timeout This command sets how long P-660HWP-Dx
lets an inactive TCP connection remain open
before considering it closed.
Config edit firewall set #> log This command sets whether or not the P-
660HWP-Dx creates logs for packets that
match the firewall’s default rule set.
Rules Config edit firewall set #> rule permit
This command sets whether packets that
match this rule are dropped or allowed
through.
Config edit firewall set #> rule active no> This command sets whether a rule is enabled
or not.
Config edit firewall set #> rule protocol
This command sets the protocol specification
number made in this rule for ICMP.
Config edit firewall set #> rule log match | not-match | both> This command sets the P-660HWP-Dx to log
traffic that matches the rule, doesn't match,
both or neither.
Config edit firewall set #> rule alert no> This command sets whether or not the P-
660HWP-Dx sends an alert e-mail when a
DOS attack or a violation of a particular rule
occurs.
config edit firewall set #> rule srcaddr-
single This command sets the rule to have the P-
660HWP-Dx check for traffic with this
individual source address.
config edit firewall set #> rule srcaddr-
subnet mask> This command sets a rule to have the P-
660HWP-Dx check for traffic from a particular
subnet (defined by IP address and subnet
mask).
config edit firewall set #> rule srcaddr-range
address> This command sets a rule to have the P-
660HWP-Dx check for traffic from this range
of addresses.
Table 168 Firewall Commands (continued)
FUNCTION COMMAND DESCRIPTION