ZyXEL Communications 802.11g HomePlug AV ADSL2+ Gateway P-660HWP-Dx User Manual
Page 371
Appendix G Firewall Commands
P-660HWP-Dx User’s Guide
37
config edit firewall attack
minute-high <0-255>
This command sets the threshold rate of new
half-open sessions per minute where the P-
660HWP-Dx starts deleting old half-opened
sessions until it gets them down to the
minute-low threshold.
config edit firewall attack
minute-low <0-255>
This command sets the threshold of half-open
sessions where the P-660HWP-Dx stops
deleting half-opened sessions.
config edit firewall attack
max-incomplete-high <0-255>
This command sets the threshold of half-open
sessions where the P-660HWP-Dx starts
deleting old half-opened sessions until it gets
them down to the max incomplete low.
config edit firewall attack
max-incomplete-low <0-255>
This command sets the threshold where the
P-660HWP-Dx stops deleting half-opened
sessions.
config edit firewall attack
tcp-max-incomplete <0-255>
This command sets the threshold of half-open
TCP sessions with the same destination
where the P-660HWP-Dx starts dropping half-
open sessions to that destination.
Sets
config edit firewall set
This command sets a name to identify a
specified set.
Config edit firewall set
This command sets whether a packet is
dropped or allowed through, when it does not
meet a rule within the set.
Config edit firewall set
This command sets the time period to allow
an ICMP session to wait for the ICMP
response.
Config edit firewall set
This command sets how long a UDP
connection is allowed to remain inactive
before the P-660HWP-Dx considers the
connection closed.
Config edit firewall set
This command sets how long P-660HWP-Dx
waits for a TCP session to be established
before dropping the session.
Config edit firewall set
This command sets how long the P-660HWP-
Dx leaves a TCP session open after the
firewall detects a FIN-exchange (indicating
the end of the TCP session).
Table 168 Firewall Commands (continued)
FUNCTION
COMMAND
DESCRIPTION