TransAct Technologies ITHERM 280 - Manual (Page 92)

Programming Codes iTherm ® 280 Programmer’s Guide
Page 90 Rev C 28-07764
[ESC] 5 Begin auto line feed
ASCII
[ESC] 5
Hexadecimal 1BH 35H
Decimal
<27> <53>
IPCL &%MA (Begin)
IPCL &%CA (End)
EPOS none
Description The [ESC] 5 <1> command sets auto line feed mode. [ESC] 5 <0>
command ends auto line feed mode.
Note: The begin and end auto line feed command overrides the
configuration setting.
[ESC] ] Reverse line feed
ASCII [ESC] ]
Hexadecimal 1BH 5DH
Decimal
<27> <93>
IPCL &%LR
EPOS none
Description The [ESC] ] command performs a reverse line feed at the current line
spacing.
Note: The iTherm ® 280 Printer can tolerate no more than 1/2 inch of
reverse feed.