TransAct Technologies ITHERM 280 User Manual
Page 110
Programming Codes
iTherm
®
280 Programmer’s Guide
Page 108
Rev C
28-07764
[ESC] _
Enable/Disable Strike Through
ASCII
[ESC] _
Hexadecimal 1BH 5FH 01H
Decimal
<27> <95>
IPCL
&%MO (Begin)
IPCL
&%CO (End)
EPOS
[ESC] !
Description The [ESC] _ <1> command begins strike through print mode. All
subsequent text, leading spaces, and trailing spaces are over-scored.
[ESC] _ <0> ends the mode.
[ESC] W
Multi-line double-wide and double-high mode
ASCII
[ESC] W
Hexadecimal 1BH 57H
Decimal
<27> <87>
IPCL
&%FD {n = 1}
&%FS {n = 0}
&%FHA {n = 3}
(Note: Single-wide, double-high mode is not available in IPCL mode.)
EPOS
[ESC] !
Description The [ESC] W
high mode, where n specifies the mode:
n = 0 is standard single-wide and single-high;
n = 1 begins double-wide;
n = 2 begins double-high; and
n = 3 begins double-wide double-high.
Note: The [ESC] W
Note: In EPOS mode, [ESC] !
near letter quality (NLQ) is not available.
Where n Bits 76543210
Function
1-------
Underline
--1-----
Double-wide
---1----
Double-high
-------X
Font: 0 = draft; 1 = large draft