TransAct Technologies ITHERM 280 - Manual (Page 88)

Programming Codes iTherm ® 280 Programmer’s Guide
Page 86 Rev C 28-07764
[ESC] 0 Set line spacing to 1/8 inch
ASCII
[ESC] 0
Hexadecimal 1BH 30H
Decimal
<27> <48>
IPCL &%ST
EPOS [ESC] 2
Description The [ESC] 0 command sets the default line spacing to 1/8 inch (27/216
inch), which is the standard eight lines per inch line spacing at initial
power-up.
Note: In EPOS mode, the command sets 1/6-inch spacing or six lines per
inch.
[ESC] 1 Set line spacing to 21/216 inch or 7/72 inch
ASCII
[ESC] 1
Hexadecimal 1BH 31H
Decimal
<27> <49>
IPCL &%SG
EPOS none
Description The [ESC] 1 command sets the default line spacing to 21/216 inch. Use
21/216-inch line spacing for all-points-addressable (APA) graphics
printing.
[ESC] A Set variable line spacing to n/72 inch
ASCII
[ESC] A
Hexadecimal 1BH 41H
Decimal
<27> <65>
IPCL none
EPOS none
Description The [ESC] A command sets the default line spacing to n/72. Set n =
1 to 85. Variable line spacing does not take effect until enabled by the
[ESC] 2 command. The command is provided to maintain backward
compatibility with the Ithaca
® Series 50, OKIDATA, IBM, and other
printers. It can also be used to print on preprinted forms.