TransAct Technologies ITHERM 280 - Manual (Page 186)

Programming Codes iTherm ® 280 Programmer’s Guide
Page 184 Rev C 28-07764
Supported TM-T88 Commands
Print Position Commands
Command Name Page
HT 09H Set horizontal tab positions 206
ESC $ 1BH,24H Set absolute print position 205
ESC D 1BH,44H Set horizontal tab positions 207
ESC \ 1BH,5CH Set relative print position 205
ESC a 1BH,61H Select justification 206
GS L 1DH,4CH Set left margin 207
GS T 1DH,54H Set print position to the beginning of the line 205
GS W 1DH,57H Set printing area width 207
Bit-image Command
Command Name Page
ESC * 1BH,2AH Select bit-image mode 209
GS v 0 1DH,76H,30
H Print raster bit image 209
Status Commands
Command Name Page
DLE EOT 10H,04H Real-time status transmission 213
DLE ENQ 10H,05H Real-time status request to printer 213
GS a 1DH,61H Enable/disable Automatic Status Back (ASB) 210
GS r 1DH,72H Transmit status 212
Bar Code Commands
Command Name Page
GS H 1DH,48H Select printing position of HRI characters 222
GS f 1DH,66H Select font HRI characters 222
GS h 1DH,68H Set bar code height 221
GS k 1DH,6BH Print bar code 220
GS w 1DH,77H Set bar code width 220
Mechanism Control Commands
Command Name Page
GS V 1DH,56H Select cut mode and cut paper 223